Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 158 (SUPPLEMENTAL INFLATABLE RESTRAINT SYSTEM)TORQUE SPECIFICATIONS
2006 Chevrolet Suburban C2500, 6.0 U
Torque Specifications
2006 Chevrolet Suburban C2500, 6.0 USECTION Torque Specifications
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) | |
|---|---|---|
| Seat mounting nuts | 44 (60) | |
| Steering wheel nut | 30 (41) | |
| INCH Lbs. (N.m) | ||
| Front end discriminating sensor nut | 89 (10.0) | |
| Instrument Panel Cluster (IPC) screws | 18 (2.0) | |
| Instrument panel | ||
| Passenger-side trim pad screws | 26 (3.0) | |
| Upper trim pad screws | 18 (2.0) | |
| Passenger-side knee bolster bracket nuts | 89 (10.0) | |
| Passenger-side air bag module mounting bolts | 89 (10.0) | |
| Sensing & Diagnostic Module (SDM) mounting nuts | 89 (10.0) | |
| Upper & lower steering column cover Torx screws | 13 (1.5) | |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.