Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Power Steering Control Module (PSCM)
The PSCM uses a combination of commanded motor voltage and current levels to calculate an estimated power steering system temperature. Neither the PSCM nor the power steering motor are designed to handle around 60 amps continuously and will enter into overload protection mode if the system is exposed to exclusive static steering conditions. If the steering wheel is turned to its maximum rotation point and held at this position for an extended period of time, the PSCM will reduce the amount of current commanded to the power steering motor, which reduces the amount of steering assist as well as system temperature. The PSCM has the ability to detect malfunctions within the power steering system. Any malfunction detected will cause the SERVICE POWER STEERING message to be displayed on the driver information center (DIC).
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.