Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1473 (VEHICLE DIAGNOSTIC INFORMATION - SCAN TOOL INFORMATION)SPECIFICATIONSINFLATABLE RESTRAINT VEHICLE ROLLOVER SENSOR SCAN TOOL INFORMATION
2006 Chevrolet Suburban C2500, 6.0 U
Inflatable Restraint Vehicle Rollover Sensor Scan Tool Information
2006 Chevrolet Suburban C2500, 6.0 USECTION Inflatable Restraint Vehicle Rollover Sensor Scan Tool Information
WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Rollover Sensor Scan Tool Data Parameters
| Parameter | System State | Expected Value | Description |
|---|---|---|---|
| Operating Conditions: Ignition ON | |||
| Average Speed | - | Varies | This displays km/h (mph). This is the average speed of the vehicle. |
| Battery Voltage Signal | - | Varies | This displays volts. This is the voltage input supplied to the rollover sensor. |
| Current Power Mode | - | Run | The scan tool displays Off, Accessory, Run or Crank Request. This is the state of the ignition switch. |
| Engine Virtual Device | - | Present | The scan tool displays Present or Not Present. |
| Primary Key Status | - | Valid | The scan tool displays Unknown, Valid or Invalid. This is the state of the primary key. |
| Received Primary Key | - | Varies | The scan tool displays the primary key received. |
| ROS Occupant Containment Req. | - | Enable | The scan tool displays Reserved, Disable or Enable. |
| ROS Primary Key | - | Varies | The scan tool displays the ROS primary key. |
| SDM Occupant Containment Status | - | Enabled | The scan tool displays Disabled or Enabled. |
| Vehicle Speed Status | - | Valid | The scan tool displays Valid or Invalid. This is the state of the vehicle speed. |
Supplemental Inflatable Restraint Scan Tool Output Controls
| Output Control | Description |
|---|---|
| Setup New ROS | This procedure should be used after a new rollover sensor has been installed. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.