Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1413 (DTC INDEX)ANTILOCK BRAKE DTCS
2006 Chevrolet Suburban C2500, 6.0 U
Antilock Brake DTCS
2006 Chevrolet Suburban C2500, 6.0 USECTION Antilock Brake DTCS
WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
ANTILOCK BRAKE DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | DEFINITION |
|---|---|
| DTC C0035, C0036, C0040, C0041, C0045, C0046, C0050, C0051 | Wheel Speed Sensor Circuit |
| DTC C0060, C0065, C0070, C0075, C0080, C0085, C0090, C0095 | ABS Solenoid Circuit |
| DTC C0110 | Pump Motor Circuit Malfunction |
| DTC C0121 | Valve Relay Circuit Malfunction |
| DTC C0161 | ABS/TCS Brake Switch Circuit Malfunction |
| DTC C0236 | TCS RPM Signal Circuit Malfunction |
| DTC C0241 | Powertrain Control Module (PCM) Indicated Requested Torque Malfunction |
| DTC C0245 | Wheel Speed Sensor Frequency Error |
| DTC C0275 or C0276 | TCM Traction Control Not Allowed |
| DTC C0550 | Electronic Control Unit (ECU) |
| DTC C0551 | Option Configuration Error |
| DTC C0896 | Device Voltage Range/Performance |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.