Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Circuit/System Description
The drive motor generator power inverter control module (PIM) contains two motor control modules (MCMs) and the hybrid powertrain control module (HPCM). Each MCM operates its respective drive motor generator based upon HPCM commands. Each MCM controls the speed, direction and output torque of its respective drive motor generator through the sequencing actuation of high current switching transistors called insulated gate bipolar transistors (IGBTs). Each drive motor generator operates utilizing 3 phase alternating current (ac) electricity. Each IGBT operates a single phase of the drive motor generator. Each phase is individually identified as U, V and W. Each MCM monitors the current of each phase in order to detect PIM overcurrent conditions.
When high voltage is enabled, each MCM supplies its respective drive motor generator with just enough current to energize the magnetic field even when no motor generator torque is required. The MCM monitors the phase current sensors for this minimal current to ensure the drive motor phase circuits are functioning properly.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.