Instrument Panel/Center Console Component Views

2006 Chevrolet Suburban C2500, 6.0 USECTION Instrument Panel/Center Console Component Views
WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Instrument Panel Overview
GM1992576Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Speaker - Left Front
2 Turn Signal/Multifunction Switch
3 Steering Wheel Control Switch Assembly - Left (-KA9)
4 Instrument Panel Cluster (IPC)
5 Steering Wheel Control Switch Assembly - Right
6 Windshield Wiper/Washer Switch
7 Sunload Sensor
8 Speaker - Front Center
9 Analog Clock
10 Inflatable Restraint I/P Module
11 Speaker - Right Front
12 Instrument Panel Compartment Lamp
13 Hazard Switch
14 Radio/Navigation Unit
15 Heated Seat Switch - Front Passenger Seat
16 Auxiliary Power Outlet - Console Front
17 HVAC Control
18 Inflatable Restraint I/P Module AIRBAG Indicator
19 Heated Seat Switch-Driver
20 Traction Control Switch
21 Air Temperature Sensor - Inside
22 Ignition Switch
23 Inflatable Restraint Steering Wheel Module
24 Data Link Connector (DLC)
25 Instrument Panel Dimmer Switch
26 Driver Information Center (DIC)
Fig 2: Brake Pedal, Accelerator Pedal, BPP and APP Sensors
GM1334064Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Accelerator Pedal Position (APP) Sensor
2 Accelerator Pedal
3 Brake Pedal
4 Brake Pedal Position (BPP) Sensor
Fig 3: HVAC Module
GM1992652Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Mode Actuator
2 Recirculation Actuator
3 Blower Motor Control Processor
4 Blower Motor
5 Air Temperature Actuator - Passenger
6 Air Temperature Actuator - Driver
Fig 4: Floor Console
GM1992685Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 A/T Shift Lock Control Solenoid (MYB)
2 Auxiliary Power Outlet - Console Front
3 Park Brake Switch
4 Auxiliary Power Outlet - Console Rear
5 Keyless Entry Antenna - Passenger Compartment (UHA/UHF)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.