Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Circuit/System Testing
2006 Chevrolet Suburban C2500, 6.0 USECTION Circuit/System Testing
WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Circuit/System Verification must be performed before performing the Circuit/System Testing.
- Turn ON the ignition, with the engine OFF.
- Verify that the low coolant indicator turns ON and OFF with each command when the instrument cluster indicators are commanded ON and OFF with a scan tool.
- If the low coolant level indicator does NOT turn ON, test for poor connections at the IPC or a faulty IPC.
- Ignition ON, disconnect the coolant level switch.
- If the low coolant level indicator turns OFF with the switch disconnected, test the coolant level switch signal circuit for a short to ground.
- If the low coolant level indicator does not turn OFF with the switch disconnected, replace the coolant level switch.
- If the signal circuit tests normal, inspect for poor connections at the BCM or a faulty BCM.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.