SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1248 (FRONT SUSPENSION SYSTEM)REPAIR INSTRUCTIONSSTABILIZER SHAFT INSULATOR REPLACEMENT (AWD )INSTALLATION PROCEDURE
2006 Chevrolet Suburban C2500, 6.0 U

Installation Procedure

2006 Chevrolet Suburban C2500, 6.0 USECTION Installation Procedure
WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the stabilizer shaft insulator to the stabilizer shaft with the slit facing rearward.
  2. Install the stabilizer shaft bracket.
    3. NOTE: Refer to Fastener Notice .
  3. Install the stabilizer shaft bracket mounting bolts.

    Tighten:  Tighten the bolts to 110 N.m (81 lb ft).

    4. Fig 1: View Of Stabilizer Shaft Link-To-Stabilizer Shaft Retaining Nuts
    GM874638Courtesy of GENERAL MOTORS CORP.
  4. Install the stabilizer shaft link to the stabilizer shaft.
  5. Install stabilizer shaft link to stabilizer shaft retaining nut.

    Tighten:  Tighten the nut to 125 N.m (92 lb ft).

  6. Install the tires and wheels. Refer to Tire and Wheel Removal and Installation .
  7. Lower the vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.