Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1247 (ANTI-LOCK BRAKE SYSTEM, TRACTION CONTROL SYSTEM & STABILITY CONTROL SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESDTC C0035-C0050CIRCUIT/SYSTEM TESTING
2006 Chevrolet Suburban C2500, 6.0 U
Circuit/System Testing
2006 Chevrolet Suburban C2500, 6.0 USECTION Circuit/System Testing
WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
It is recommended that Component Testing is performed before Circuit Testing when diagnosing wheel speed sensors.
- Ignition OFF, disconnect the harness connector at the EBCM.
- Ignition ON, test for less than 1 volt between the low reference circuit terminals of the appropriate sensor listed below and ground.
- LF Sensor circuit terminal 28
- RF Sensor circuit terminal 17
- LR Sensor circuit terminal 4
- RR Sensor circuit terminal 3
- If greater than the specified value, test the low reference circuit for a short to voltage. If the circuit tests normal, replace the wheel speed sensor
- Test for less than 1 volt between the signal circuit terminals of the appropriate sensor listed below and ground.
- LF Sensor circuit terminal 29
- RF Sensor circuit terminal 6
- LR Sensor circuit terminal 5
- RR Sensor circuit terminal 2
- If greater than the specified value, test the signal circuit for a short to voltage. If the circuit tests normal, replace the wheel speed sensor.
- Ignition OFF, test for infinite resistance between the low reference terminals of the appropriate sensor listed below and ground.
- LF Sensor circuit terminal 28
- RF Sensor circuit terminal 17
- LR Sensor circuit terminal 4
- RR Sensor circuit terminal 3
- If less than the specified value, test the low reference circuit for a short to ground. If the circuit tests normal, test or replace the wheel speed sensor.
- Test for infinite resistance between the following signal circuit terminals of the appropriate sensor listed below and ground.
- LF Sensor circuit terminal 29
- RF Sensor circuit terminal 6
- LR Sensor circuit terminal 5
- RR Sensor circuit terminal 2
- If less than the specified value, test the signal circuit for a short to ground. If the circuit tests normal, test or replace the wheel speed sensor.
- If all circuits test normal, replace the EBCM.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.