Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1244 (MIRROR SYSTEMS)REPAIR INSTRUCTIONSINSIDE REARVIEW MIRROR REPLACEMENT

2006 Chevrolet Suburban C2500, 6.0 U

Inside Rearview Mirror Replacement

2006 Chevrolet Suburban C2500, 6.0 USECTION Inside Rearview Mirror Replacement

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Inside Rearview Mirror Replacement

Courtesy of GENERAL MOTORS CORP.

Callout

Component Name

Rearview Mirror Support Wire Cover

Rearview Mirror Support Screw

NOTE: Refer to Fastener Notice .

Procedure

Disconnect the electrical connector from the mirror.
Adjust the mirror to the full upward position.
Loosen the screw in order to remove the mirror from the button assembly.
Slide the mirror assembly in an upward motion in order to remove.

Tighten: 1.8 N.m(16 lb in).

Rearview Mirror

Procedure

Position the center bottom of the mirror mount against the windshield at the top of the support button.
Slide the base of the mirror onto the button.
Refer to Control Module References for programming and setup information.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.