Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
4.8L, 5.3L & 6.0L
2006 Chevrolet Suburban C2500, 6.0 USECTION 4.8L, 5.3L & 6.0L
WARNING: This page is about a different car, the 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Silverado, and 2003 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
The column labeled Data List indicates where a parameter is located on the scan tool. Review the scan tool operating manual for the exact locations of the data lists. The following is a description of each term listed.
- All
The parameter is in all of the data lists indicated below. - Eng 1
Engine Data 1 List - Eng 2
Engine Data 2 List - EE
Enhanced Evaporative Emission (EVAP) Data - FF/FR
Freeze Frame/Failure Records - FT
Fuel Trim Data List - MF
Misfire Data List - TAC
Throttle Actuator Control (TAC) Data List - CC
Cruise Control Data List - HO2S Data
Heated Oxygen Sensor (HO2S) Data List
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.