Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Infotainment Faceplate Control Module
The operator interfaces with the radio system through the buttons and control knobs located on the Infotainment Faceplate Control Module or faceplate. The operator is able to control system power, volume, fade, balance, bass, and treble equalizations. When the operator turns a knob or pushes a button, a module in the faceplate sends a signal to the radio on a UART - based bus called CAN Graphical Interface (CGI). The CGI bus circuit is part of a wiring harness that connects the faceplate and radio.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.