SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1130 (WIPER SYSTEM & WASHER SYSTEM)REPAIR INSTRUCTIONSWINDSHIELD WIPER SYSTEM MODULE REPLACEMENT
2006 Chevrolet Suburban C2500, 6.0 U

Windshield Wiper System Module Replacement

2006 Chevrolet Suburban C2500, 6.0 USECTION Windshield Wiper System Module Replacement
WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Windshield Wiper System Module Assembly & Bolts
GM1669964Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedure

  1. Remove the wiper arms. Refer to Windshield Wiper Arm Replacement (LD) .
  2. Remove the air inlet grille panels. Refer to Air Inlet Grille Panel Replacement .
1 Windshield Wiper System Module Assembly Bolt (Qty: 3)
NOTE: Refer to Fastener Notice .

Tighten:  9 N.m (80 lb in)
2 Windshield Wiper System Module Assembly
Tip:  Raise the module from the plenum and disconnect the electrical connector from the I/P harness.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.