Front Floor Console Compartment Replacement

2006 Chevrolet Suburban C2500, 6.0 USECTION Front Floor Console Compartment Replacement
WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Front Floor Console Compartment
GM1693890Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedures

  1. Remove the front floor console. Refer to Front Floor Console Replacement (with RPO SLT)Β  or Front Floor Console Replacement (without RPO SLT)Β .
  2. Remove the front floor console end panel. Refer to Center Console End Panel ReplacementΒ .
1 Front Floor Console Compartment Screws (Qty: 14)
NOTE: Refer to Fastener Notice .

Tighten:Β  2 N.m (18 lb in)

2 Front Floor Console Compartment Assembly
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.