SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1059 (SECONDARY AND CONFIGURABLE CUSTOMER CONTROLS)REPAIR INSTRUCTIONSSTEERING WHEEL CONTROL SWITCH ASSEMBLY REPLACEMENT
2006 Chevrolet Suburban C2500, 6.0 U

Steering Wheel Control Switch Assembly Replacement

2006 Chevrolet Suburban C2500, 6.0 USECTION Steering Wheel Control Switch Assembly Replacement
WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Steering Wheel Control Switch Assembly
GM1704178Courtesy of GENERAL MOTORS CORP.
Steering Wheel Control Switch Assembly Replacement

Callout Component Name
CAUTION: Refer to SIR Caution .

Preliminary Procedure

  1. Disable the supplemental inflatable restraint (SIR) system. Refer to SIR Disabling and Enabling .
  2. Remove the steering wheel. Refer to Steering Wheel Replacement .
  3. Remove the horn switch. Refer to Horn Switch Replacement .
1 Steering Wheel Trim Cover (Qty: 2)
Tip:  Remove the 4 horn contact screws.
2 Steering Wheel Control Switch Assembly Screw (Qty: 4)
Tip: 
  • Quantity may vary with vehicle options.
  • DO NOT over tighten the steering wheel control switch screws or damage to the switch(s) or steering wheel covers may occur.
3 Steering Wheel Control Switch Assembly (Qty: 2)
Tip: 
  • Quantity may vary with vehicle options.
  • Make sure the steering wheel control switch(s) are properly seated to the steering wheel shroud during installation.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.