SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1026 (ANTI-LOCK BRAKE SYSTEM, TRACTION CONTROL SYSTEM & STABILITY CONTROL SYSTEM)REPAIR INSTRUCTIONSELECTRONIC BRAKE CONTROL MODULE REPLACEMENT (JH6, JH7)
2006 Chevrolet Suburban C2500, 6.0 U

Electronic Brake Control Module Replacement (JH6, JH7)

2006 Chevrolet Suburban C2500, 6.0 USECTION Electronic Brake Control Module Replacement (JH6, JH7)
WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Electronic Brake Control Module & Screws
GM1862946Courtesy of GENERAL MOTORS CORP.
Electronic Brake Control Module Replacement (JH6, JH7)

Callout Component Name
NOTE: Always connect or disconnect the wiring harness connector from the EBCM/EBTCM with the ignition switch in the OFF position. Failure to observe this precaution could result in damage to the EBCM/EBTCM.

Preliminary Procedures

  1. Turn the ignition switch to the OFF position.
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  3. Remove any dirt and debris from the area of the brake pressure modulator valve (BPMV)/electronic brake control module (EBCM) assembly.
1 EBCM to BPMV Screw (Qty: 4)
NOTE: Refer to Fastener Notice .

Procedure

  1. Discard the EBCM to BPMV screws.
  2. Install new EBCM to BPMV screws.
  3. Tighten the EBCM to BPMV screws in an X pattern.

Tighten:  3 N.m (27 lb in)
2 Electronic Brake Control Module (EBCM)

Procedure

  1. Disconnect the EBCM electrical connector.
  2. Carefully pull the EBCM away from the BPMV. Do not force the components apart.
  3. Clean the EBCM to BPMV sealing surfaces with denatured alcohol and allow to dry.
  4. Program the EBCM. Refer to Control Module References .
  5. Bleed the antilock brake system. Refer to Antilock Brake System Automated Bleed Procedure (W/O JL4)  or Antilock Brake System Automated Bleed Procedure (W/JL4) .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.