Diagnostic Code Index

2006 Chevrolet Suburban C2500, 6.0 USECTION Diagnostic Code Index
WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC CODE INDEX

DTC Description
DTC C0055 or P0609  Rear Wheel Speed Sensor Circuit
DTC C0035 or C0040  Front Wheel Speed Sensor Circuit
DTC C0045 or C0050  Rear Wheel Speed Sensor Circuit
DTC C0110 (Under 8600 GVW)  Pump Motor Circuit
DTC C0110 (Equal to or over 8600 GVW)  Pump Motor Circuit
DTC C0131  ABS/TCS System Pressure Circuit
DTC C0161 (Under 8600 GVW)  Antilock Brake System (ABS) Brake Switch/Sensor Circuit Not Plausible
DTC C0186  Lateral Accelerometer Circuit
DTC C0196  Yaw Rate Circuit
DTC C0201 (Under 8600 GVW)  Antilock Brake System (ABS) Enable Relay Contact Circuit
DTC C0201 (Equal to or over 8600 GVW)  Antilock Brake System (ABS) Enable Relay Contact Circuit
DTC C0242  Electronic control module (ECM) Indicated TCS Malfunction
DTC C0245  Wheel Speed Sensor Frequency Error
DTC C0252  VSES Sensor Uncorrelated
DTC C0253  Centering Error
DTC C0299  Brake Booster Pressure Sensor
DTC C0455  Front Steering Position Sensor Circuit
DTC C0550  Electronic Control Unit (ECU) Performance
DTC C0561  System Disabled Information Stored Invalid Serial Data Received
DTC C0569  System Configuration Error
DTC C0710  Steering Position Signal
DTC C0774  Low Tire Pressure System Performance
DTC C1100 or C1101  Brake Booster Vacuum Sensor Performance
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.