SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1012 (WIPER SYSTEM & WASHER SYSTEM)REPAIR INSTRUCTIONSWINDSHIELD WIPER SYSTEM MODULE REPLACEMENT
2006 Chevrolet Suburban C2500, 6.0 U

Windshield Wiper System Module Replacement

2006 Chevrolet Suburban C2500, 6.0 USECTION Windshield Wiper System Module Replacement
WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Windshield Wiper System Module Assembly & Bolts
GM1669964Courtesy of GENERAL MOTORS CORP.
Windshield Wiper System Module Replacement

Callout Component Name

Preliminary Procedure

  1. Remove the wiper arms. Refer to Windshield Wiper Arm Replacement (LD)  or Windshield Wiper Arm Replacement (HD) .
  2. Remove the air inlet grille panels. Refer to Air Inlet Grille Panel Replacement .
1 Windshield Wiper System Module Assembly Bolt (Qty: 3)
NOTE: Refer to Fastener Notice .

Tighten:  9 N.m (80 lb in)
2 Windshield Wiper System Module Assembly
Tip:  Raise the module from the plenum and disconnect the electrical connector from the I/P harness.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.