Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C2500, 6.0 UREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1000 (CELLULAR SYSTEM, ENTERTAINMENT SYSTEM, AND NAVIGATION SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESVIDEO ENTERTAINMENT SYSTEM INOPERATIVECIRCUIT/SYSTEM TESTING
2006 Chevrolet Suburban C2500, 6.0 U
Circuit/System Testing
2006 Chevrolet Suburban C2500, 6.0 USECTION Circuit/System Testing
WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
If rear video display turns ON but the video is blank, use diagnostic Video Display is Poor or Blank .
- Disconnect the rear video display harness connector. With the ignition ON, operate the rear entertainment system. Verify there is voltage on the remote enable signal circuit.
- If voltage is not present on the remote enable signal circuit, test and repair open or short to ground.
- If the enable signal circuit tests normal but there is no voltage, replace the radio.
- Test and repair open, short to ground and short to power on the ground and battery positive voltage circuits at the rear video display.
- If the video display power and ground circuits test normal, replace the rear video display.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.