Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C2500, 6.0 UREPAIR AND DIAGNOSISBRAKESANTILOCK BRAKE SYSTEM WITH TRACTION CONTROL SYSTEM & STABILITY CONTROL SYSTEMREPAIR INSTRUCTIONSWHEEL SPEED SENSOR REPLACEMENT - FRONT (4 WHEEL DRIVE)REMOVAL PROCEDURE
2006 Chevrolet Suburban C2500, 6.0 U
Removal Procedure
2006 Chevrolet Suburban C2500, 6.0 USECTION Removal Procedure
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
- Remove the brake rotor (2) shown on the 1500 Series. Refer to Brake Rotor Replacement - Front in Disc Brakes.
- Remove the wheel speed sensor (WSS) cable mounting clip from the knuckle.
- Remove the WSS cable mounting clip from the upper control arm.
- Remove the WSS cable mounting clip from the frame attachment point.
- Remove the WSS cable electrical connector.
- Remove the WSS mounting bolt.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.