Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C2500, 6.0 UREPAIR AND DIAGNOSISBODY & FRAMESEATSSEAT SYSTEMREPAIR INSTRUCTIONSMODULE REPLACEMENT - SEAT CLIMATE CONTROL - REAR SEATREMOVAL PROCEDURE
2006 Chevrolet Suburban C2500, 6.0 U
Removal Procedure
2006 Chevrolet Suburban C2500, 6.0 USECTION Removal Procedure
- Position the seat cushion in the forward position.
- Release the seat cushion trim cover J channel along the lower edge of the trim cover. Refer to Seat Cushion Cover and Pad Replacement - Rear (60/40 Split - 50/50 Split) or Seat Cushion Cover and Pad Replacement - Rear (Bench) .
- Disconnect electrical connections (3) from the seat climate control module (1).
- Note the location of the tie straps (2) securing the climate control module.
- Remove the tie straps (2) securing the module to the seat cushion frame.
- Remove the module from the seat cushion frame.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.