Removal Procedure

2006 Chevrolet Suburban C1500, 5.3 ZSECTION Removal Procedure
WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place the module in the full open position.
  2. Remove the headliner. Refer to Headlining Trim Panel Replacement (Regular Cab) or Headlining Trim Panel Replacement (Extended Cab) or Headlining Trim Panel Replacement (Crew Cab) .
  3. Disconnect the electrical connector from the motor/actuator.
  4. Remove the motor/actuator. Refer to Sunroof Motor/Actuator Replacement (Extended Cab)Β  or Sunroof Motor/Actuator Replacement (Crew Cab)Β .
  5. Push the window guides rearward on the track until the guides are positioned against the rear hard stop.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.