SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C1500, 5.3 ZREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 909 (HEATING, VENTILATION, AND AIR CONDITIONING)REPAIR INSTRUCTIONSBLOWER MOTOR CONTROL MODULE REPLACEMENT
2006 Chevrolet Suburban C1500, 5.3 Z

Blower Motor Control Module Replacement

2006 Chevrolet Suburban C1500, 5.3 ZSECTION Blower Motor Control Module Replacement
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Blower Motor Control Module & Screws
GM1696338Courtesy of GENERAL MOTORS CORP.
Blower Motor Control Module Replacement

Callout Component Name

Preliminary Procedure

  1. Remove the I/P insulator panel. Refer to Instrument Panel Insulator Replacement (Cadillac) or Instrument Panel Insulator Replacement (Except Cadillac) .
  2. Disconnect the blower motor control module electrical connector.
1 Screw, Blower Motor Control Module (Qty: 2)
NOTE: Refer to Fastener Notice .

Tighten:  1.5 N.m (13 lb in)
2 Module, Blower Motor Control
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.