Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C1500, 5.3 ZREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 801 (WIPERS SYSTEM AND WASHER SYSTEM)COMPONENT LOCATORWIPER/WASHER CONNECTOR END VIEWSWINDSHIELD WIPER/WASHER SWITCH
2006 Chevrolet Suburban C1500, 5.3 Z
Windshield Wiper/Washer Switch
2006 Chevrolet Suburban C1500, 5.3 ZSECTION Windshield Wiper/Washer Switch
WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
Windshield Wiper/Washer Switch Connector Parts Information
Connector Part Information
|
Windshield Wiper/Washer Switch Connector Terminal Identification
| Pin | Wire Color | Circuit No. | Function |
|---|---|---|---|
| A | BK | 550 | Ground |
| B | D-GN | 392 | Rear Window Washer Pump Control |
| C | D-GN | 113 | Windshield Wiper Switch Signal |
| D | GY | 112 | Low Reference |
| E | PK | 94 | Rear Wiper Switch Signal |
| F | YE | 343 | Accessory Voltage |
| G | PU | 92 | Windshield Wiper Motor High Speed |
| H | D-GN | 95 | Windshield Wiper Motor Low Speed |
| J | L-BU | 97 | Windshield Wiper Switch Mist/Off/Low Signal |
| K | BN | 96 | Windshield Wiper Switch Pulse Delay Signal |
| L | - | - | Not Used |
| M | RD | 228 | Windshield Washer Pump Control |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.