Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBβ LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C1500, 5.3 ZREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 678 (ENGINE CONTROLS - 4.3L - INTRODUCTION (2 OF 2))COMPONENT LOCATORENGINE CONTROLS COMPONENT VIEWS
2006 Chevrolet Suburban C1500, 5.3 Z
Engine Controls Component Views
2006 Chevrolet Suburban C1500, 5.3 ZSECTION Engine Controls Component Views
WARNING: This page is about a different car, the 2006 GMC Sierra and 2006 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Callouts For Fig 1
| Callout | Component Name |
|---|---|
| 1 | Fuse Block - Underhood |
| 2 | Battery - Left |
| 3 | Powertrain Control Module (PCM) |
| 4 | Battery - Right (8Y9/TP2) |
Callouts For Fig 2
| Callout | Component Name |
|---|---|
| 1 | Air Cleaner Assembly |
| 2 | Mass Air Flow (MAF)/Intake Air Temperature (IAT) Sensor |
| 3 | Air Inlet Tube |
| 4 | Generator |
Callouts For Fig 3
| Callout | Component Name |
|---|---|
| 1 | Ignition Control Module (ICM) |
| 2 | Throttle Position (TP) Sensor |
| 3 | Central Sequential Fuel Injection (Central SFI) |
| 4 | Idle Air Control (IAC) Valve |
| 5 | Engine Coolant Temperature (ECT) Sensor |
Callouts For Fig 4
| Callout | Component Name |
|---|---|
| 1 | Evaporative Emission (EVAP) Canister Purge Solenoid |
| 2 | Ignition Coil |
| 3 | Manifold Absolute Pressure (MAP) Sensor |
| 4 | Crankshaft Position (CKP) Sensor |
Callouts For Fig 5
| Callout | Component Name |
|---|---|
| 1 | Camshaft Position (CMP) Sensor |
| 2 | Knock Sensor (KS) |
| 3 | Engine Oil Pressure (EOP) Sensor |
Callouts For Fig 6
| Callout | Component Name |
|---|---|
| 1 | HO2S Bank 2 Sensor 2 |
| 2 | HO2S Bank 1 Sensor 2 |
| 3 | HO2S Bank 1 Sensor 1 |
| 4 | HO2S Bank 2 Sensor 1 |
Callouts For Fig 7
| Callout | Component Name |
|---|---|
| 1 | Fuel Pump and Sender Assembly |
| 2 | Evaporative Emissions (EVAP) Canister Vent Solenoid |
Callouts For Fig 8
| Callout | Component Name |
|---|---|
| 1 | Fuel Tank |
| 2 | Fuel Tank Pressure (FTP) Sensor Connector |
| 3 | Fuel Level Sensor |
| 4 | Fuel Pump and Sender Assembly |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.