Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C1500, 5.3 ZREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 543 (LIGHTING SYSTEMS)REPAIR INSTRUCTIONSBACKUP LAMP REPLACEMENTINSTALLATION PROCEDURE
2006 Chevrolet Suburban C1500, 5.3 Z
Installation Procedure
2006 Chevrolet Suburban C1500, 5.3 ZSECTION Installation Procedure
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
- Install the backup lamp sockets to the backup lamp assembly.
Rotate the sockets clockwise to engage the locking tabs.
- Install the backup lamp assembly into position on the vehicle.
- Install the backup lamp assembly retaining screws.
Tighten: Tighten the backup lamp and rear license assembly retaining screws to 2 N.m (18 lb in).
- Install the rear license plate.
- Install the rear license frame.
Align the locking tabs, then press engage.
NOTE:
Refer to Fastener Notice in Cautions and Notices.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.