SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C1500, 5.3 ZREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 540 (WIRING SYSTEMS - SPECIFICATIONS, COMPONENT VIEWS AND CONNECTOR END VIEWS)COMPONENT LOCATORINLINE HARNESS CONNECTOR END VIEWSC400
2006 Chevrolet Suburban C1500, 5.3 Z

Inline Harness Connector End Views: C400

2006 Chevrolet Suburban C1500, 5.3 ZSECTION C400
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
C400 Transmission Harness Terminal Identification To Rear Body Harness

GM229958Courtesy of GENERAL MOTORS CORP.
Connector Part Information
  • 12047932
  • 8-Way F Metri-Pack 150 Series (BLK)
 Connector Part Information
  • 12047931
  • 8-Way M Metri-Pack 150 Series (BLK)
Pin Wire Color Circuit No. Function Pin Wire Color Circuit No. Function
A BLK 150 Ground A BLK 150 Ground
B YEL 820 CHMSL Supply Voltage B YEL 820 CHMSL Supply Voltage
C LT GRN 24 Backup Lamp Supply Voltage C LT GRN 24 Backup Lamp Supply Voltage
D YEL 18 Left Rear Stop/Turn Lamp Supply Voltage D YEL 18 Left Rear Stop/Turn Lamp Supply Voltage
E BRN 9 Park Lamp Supply Voltage E BRN 9 Park Lamp Supply Voltage
F - - Not Used F - - Not Used
G DK GRN 19 Right Rear Stop/Turn Lamp Supply Voltage G DK GRN 19 Right Rear Stop/Turn Lamp Supply Voltage
H RED 122 Rear Fog Lamp Supply Voltage (Europe) H RED 122 Rear Fog Lamp Supply Voltage (Europe)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.