SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C1500, 5.3 ZREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 540 (WIRING SYSTEMS - SPECIFICATIONS, COMPONENT VIEWS AND CONNECTOR END VIEWS)COMPONENT LOCATORINLINE HARNESS CONNECTOR END VIEWSC301
2006 Chevrolet Suburban C1500, 5.3 Z

Inline Harness Connector End Views: C301

2006 Chevrolet Suburban C1500, 5.3 ZSECTION C301
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
C301 Instrument Panel Harness Terminal Identification To Drivers Seat Harness

GM62455Courtesy of GENERAL MOTORS CORP.
Connector Part Information
  • 12064752
  • 6-Way F Metri-Pack 280 Series (BLK)
 Connector Part Information
  • 12064754
  • 6-Way M Metri-Pack 280 Series (BLK)
Pin Wire Color Circuit No. Function Pin Wire Color Circuit No. Function
A BLK/WHT 238 Seat Belt Switch Signal -Driver A BLK/WHT 238 Seat Belt Switch Signal -Driver
BLK/WHT 238 Seat Belt Switch Signal -Driver
B BRN/WHT 1048 SCM (Seat) Class 2 Serial Data B BRN/WHT 1048 SCM (Seat) Class 2 Serial Data
C ORN 1840 Battery Positive Voltage C ORN 1840 Battery Positive Voltage
D BLK 150 Ground D BLK 150 Ground
BLK 150 Ground (W/AR9)
E ORN 1740 Battery Positive Voltage E ORN 1740 Battery Positive Voltage
ORN 1740 Battery Positive Voltage
F ORN 1140 Battery Positive Voltage F ORN 1140 Battery Positive Voltage
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.