SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C1500, 5.3 ZREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 540 (WIRING SYSTEMS - SPECIFICATIONS, COMPONENT VIEWS AND CONNECTOR END VIEWS)COMPONENT LOCATORINLINE HARNESS CONNECTOR END VIEWSC215
2006 Chevrolet Suburban C1500, 5.3 Z

Inline Harness Connector End Views: C215

2006 Chevrolet Suburban C1500, 5.3 ZSECTION C215
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
C215 Instrument Panel Harness Terminal Identification To Hazard Warning Switch Jumper Harness

GM39763Courtesy of GENERAL MOTORS CORP.
Connector Part Information
  • 12064769
  • 10-Way F Metri-Pack 150 Series (NAT)
 Connector Part Information
  • 12064770
  • 10-Way M Metri-Pack 150 Series (NAT)
Pin Wire Color Circuit No. Function Pin Wire Color Circuit No. Function
A BLK 150 Ground A BLK 150 Ground
B ORN 140 Battery Positive Voltage B ORN 140 Battery Positive Voltage
C PNK 1739 Ignition 1 Voltage C PNK 1739 Ignition 1 Voltage
D - - Not Used D - - Not Used
E GRY/BLK 1458 Hazard Switch Signal E GRY/BLK 1458 Hazard Switch Signal
F LT BLU 14 Left Turn Signal Status Signal F LT BLU 14 Left Turn Signal Status Signal
G DK BLU 15 Right Turn Signal Status Signal G DK BLU 15 Right Turn Signal Status Signal
H PPL 16 Turn Signal Flasher Signal H PPL 16 Turn Signal Flasher Signal
J BRN 27 Hazard Flasher Signal J BRN 27 Hazard Flasher Signal
K WHT 17 Stop Lamp Switch Signal K WHT 17 Stop Lamp Switch Signal
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.