Component Locations

2006 Chevrolet Suburban C1500, 5.3 ZSECTION Component Locations
WARNING: This page is about a different car, the 2003 GMC Sierra and 2003 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: For component locations refer to COMPONENT LOCATIONSΒ  table or illustrations. See Fig 1 -Fig 9 .
COMPONENT LOCATIONS

Component Location
Body Control Module Below Steering Column
Camshaft Position Sensor Top Center Rear Of Engine
Crankshaft Position Sensor Lower Right Rear Of Engine
Data Link Connector Lower Left Side Of Instrument Panel
EGR Valve Top Right Front Of Engine
Engine Coolant Temperature Sensor Left Front Of Cylinder Head
EVAP Canister Purge Solenoid Top Right Rear Of Engine
EVAP Canister Vent Solenoid Left Front Side Of Fuel Tank
Fuel Pump Relay In Underhood Fuse/Relay Block
Fuel Tank Pressure Sensor In Fuel Tank
Heated Oxygen Sensor - Bank 1, Sensor 1 Left Exhaust Pipe, Ahead Of Catalytic Converter
Heated Oxygen Sensor - Bank 1, Sensor 2 Left Exhaust Pipe, After Catalytic Converter
Heated Oxygen Sensor - Bank 2, Sensor 1 Right Exhaust Pipe, Ahead Of Catalytic Converter
Heated Oxygen Sensor - Bank 2, Sensor 2 Right Exhaust Pipe, After Catalytic Converter
Idle Air Control Valve On Throttle Body
Ignition Control Module Top Right Side Of Engine
Knock Sensor Rear Of Engine Block
Manifold Absolute Pressure Sensor Top Rear Of Engine
Mass Airflow Sensor In Air Intake Duct
Secondary Air Injection Reaction Pump Right Rear Of Engine Compartment
Secondary Air Injection Reaction Relay Right Rear Of Engine Compartment
Secondary Air Injection Reaction Solenoid Right Rear Of Engine Compartment
Throttle Position Sensor On Throttle Body Assembly
Vehicle Speed Sensor Left Rear Of Transmission
Fig 1: Locating Crankshaft Position Sensor
G98H63401Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.