Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Scan Tool Data Definitions
- Courtesy Lamp Switch
-
Input showing state of the courtesy lamp as commanded by the BCM.
- Cargo Door Ajar Switch
-
Input from the liftgate and liftglass indicating their status.
- Driver Door Ajar Switch (w/o DDM)
-
Input from the driver door indicating door status.
- Left Rear/Rear Cargo Door Ajar Switch
-
Input from the left rear door indicating its status.
- Passenger Door Ajar Switch (w/o PDM)
-
Input from the front passenger door indicating door status.
- RAP Relay
-
Output indicates the RAP Relay state that the control module has commanded.
- Right Rear Door Ajar Sw.
-
Input from the right rear door indicating door status.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.