Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C1500, 5.3 ZREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 403 (AUTOMATIC TRANSMISSION - ALLISON (INTRODUCTION, SERVICE & REPLACEMENT))REPAIR INSTRUCTIONSTRANSMISSION CONTROL MODULE REPROGRAMMING PROCEDURESPROGRAMMING USING SCAN TOOL PASS-THROUGH CONNECTION
2006 Chevrolet Suburban C1500, 5.3 Z
Programming Using Scan Tool Pass-Through Connection
2006 Chevrolet Suburban C1500, 5.3 ZSECTION Programming Using Scan Tool Pass-Through Connection
WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Connect the scan tool to vehicle and power it up.
- Connect the computer station to the scan tool.
- Select "PC Using Scan Tool Connection" from the programming menu on the computer station.
- Follow the menu select items for reprogramming and provide information as to what type of device you are programming and whether you are reprogramming or replacing the Electronic Control Unit (ECU).
- Select "vehicle" from the selection menu.
- Select the module you wish to Program/Reprogram.
- Select "Normal" for Programming Type.
- Select the applicable software calibrations.
- Transfer data file to the scan tool.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.