Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C1500, 5.3 ZREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 382 (ENGINE CONTROLS - 4.3L (INTRODUCTION))REPAIR INSTRUCTIONSFUEL PRESSURE REGULATOR REPLACEMENTINSTALLATION PROCEDURE

2006 Chevrolet Suburban C1500, 5.3 Z

Installation Procedure

2006 Chevrolet Suburban C1500, 5.3 ZSECTION Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra and 2004 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: If the fuel pressure regulator is to be reinstalled, inspect the filter screen for contamination. If the filter screen is contaminated, replace the regulator.

Lubricate the NEW O-rings with clean engine oil.
Assemble the following NEW parts to the fuel pressure regulator:
- Backup ring (7)
- Regulator seal O-ring (8)
- Regulator (9)
- Regulator seal O-ring (10)
Install the fuel pressure regulator with the vacuum tube pointing down.
Install the fuel pressure regulator retainer clip (5).

Fig 1: View Of Fuel Meter Body Assembly Components

Courtesy of GENERAL MOTORS CORP.

Install the upper manifold. Refer to Intake Manifold Replacement - Upper in Engine Mechanical-4.3L.
Tighten the fuel fill cap.
Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (Single Battery) or Battery Negative Cable Disconnect/Connect Procedure (Auxiliary Battery) in Engine Electrical.
Inspect for leaks.
1. Turn the ignition ON, for 2 seconds.
2. Turn the ignition OFF, for 10 seconds.
3. Turn the ignition ON.
4. Inspect for fuel leaks.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.