Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C1500, 5.3 ZREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 382 (ENGINE CONTROLS - 4.3L (INTRODUCTION))REPAIR INSTRUCTIONSAIR CLEANER OUTLET RESONATOR REPLACEMENTINSTALLATION PROCEDURE

2006 Chevrolet Suburban C1500, 5.3 Z

Installation Procedure

2006 Chevrolet Suburban C1500, 5.3 ZSECTION Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra and 2004 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Install the air cleaner outlet resonator.

Fig 1: View Of Air Cleaner Outlet Resonator

Courtesy of GENERAL MOTORS CORP.

Align the hinge clip with the lip on the throttle body. Install the air cleaner outlet resonator to the throttle body by pivoting the resonator downward until the stud is through the hole in the resonator.

Fig 2: View Of Air Cleaner Outlet Duct

Courtesy of GENERAL MOTORS CORP.

Install the air cleaner outlet resonator wing nut.

Fig 3: View Of Air Cleaner Adapter Nut

Courtesy of GENERAL MOTORS CORP.

Install the air cleaner outlet resonator to the MAF/IAT sensor.
NOTE: Refer to Fastener Notice in Cautions and Notices.
Tighten the air cleaner outlet duct clamp at the MAF/IAT sensor.
Tighten: Tighten the clamp to 4 N.m (35 lb in).

Fig 4: View Of Air Cleaner Outlet Duct Clamp

Courtesy of GENERAL MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.