Installation Procedure

2006 Chevrolet Suburban C1500, 5.3 ZSECTION Installation Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the washer pump to the new washer solvent container.
  2. Install the washer solvent container cap.
    Fig 1: Installing Washer Pump
    G02422371Courtesy of GENERAL MOTORS CORP.
  3. Connect the electrical connector to the washer pump.
  4. Remove the cap on the washer pump and connect the washer hose to the washer pump.
  5. Position the washer solvent container into the locating holes in the chassis.
    Fig 2: Connecting Electrical Connector & Washer Hose
    G02422372Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.