SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C1500, 5.3 ZREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 217 (ANTILOCK BRAKE SYSTEM)REPAIR INSTRUCTIONSELECTRONIC BRAKE CONTROL MODULE (EBCM) REPLACEMENTREMOVAL PROCEDURE
2006 Chevrolet Suburban C1500, 5.3 Z

Removal Procedure

2006 Chevrolet Suburban C1500, 5.3 ZSECTION Removal Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

Important  : After installation, calibrate the new EBCM to the tire size that is appropriate to the vehicle.

  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure .
  2. Raise and suitably support the vehicle.

    Important  : The area around the EHCU MUST be free from loose dirt to prevent contamination of disassembled ABS components.

  3. Thoroughly wash all contaminants from around the EHCU.
  4. For cutaway vehicles, remove the splash shield.
    Fig 1: Removing Splash Shield
    G01216206Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the electrical connectors from the EBCM.
    Fig 2: Disconnecting Electrical Connectors From EBCM
    G01216205Courtesy of GENERAL MOTORS CORP.
  6. Remove the mounting screws that fasten the EBCM (2) to the BPMV (1).
  7. Remove the EBCM (2) from the BPMV (1). Removal may require a light amount of force.
  8. Clean the BPMV to EBCM mounting surfaces with a clean cloth.
    Fig 3: Removing EBCM From BPMV
    G01216207Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.