Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C1500, 5.3 ZREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2054 (KEYLESS ENTRY SYSTEM AND REMOTE FUNCTIONS)DESCRIPTION AND OPERATIONKEYLESS ENTRY SYSTEM DESCRIPTION AND OPERATIONVEHICLE LOCATOR/PANIC ALARM
2006 Chevrolet Suburban C1500, 5.3 Z
Vehicle Locator/Panic Alarm
2006 Chevrolet Suburban C1500, 5.3 ZSECTION Vehicle Locator/Panic Alarm
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
A single press of the panic button performs the following functions. Some functions may be dependent on personalization settings:
- Pulse the horn 3 times.
- Flash the exterior lamps 3 times.
A press and hold of the panic button performs the following functions:
- Illuminate the interior lamps.
- Pulse the horn and flash the exterior lamps for 30 seconds or until the following conditions occur:
- The panic button is pressed.
- The ignition switch is turned to the RUN position with a valid key.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.