Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C1500, 5.3 ZREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2013 (AUTOMATIC TRANSMISSION - 2ML70 - COMPONENT LOCATOR)COMPONENT LOCATORDISASSEMBLED VIEWSINTERNAL COMPONENTS
2006 Chevrolet Suburban C1500, 5.3 Z
Internal Components
2006 Chevrolet Suburban C1500, 5.3 ZSECTION Internal Components
WARNING: This page is about a different car, the 2011 GMC Yukon, 2011 Chevrolet Tahoe, and 2011 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| 60 | Input Shaft Thrust Bearing |
| 61 | Internal Gear Retaining Ring - 1st Position |
| 62 | Input Shaft Fluid Seal Ring |
| 63 | A/Trans Torque Dampener Clutch Fluid Seal Ring |
| 64 | Input Shaft |
| 65 | Internal Gear - 1st Position |
| 66 | Sun Gear Carrier Thrust Bearing - 1st Position |
| 67 | Sun Gear Carrier Assembly - 1st Position |
| 69 | Sun Gear Assembly - 1st Position |
| 70 | Generator Drive Motor Bolt |
| 71 | Drive Motor (w/Generator) Assembly - 1st Position |
| 72 | Generator Drive Motor Housing Seal |
| 73 | Sun Gear Shaft Retaining Ring |
| 74 | Sun Gear Shaft Assembly - 1st Position |
| 75 | Internal Gear - 2nd Position |
| 76 | Internal Gear Thrust Bearing Assembly - 2nd Position |
| 77 | Sun Gear Carrier Assembly - 2nd Position |
| 79 | Sun Gear Assembly - 2nd Position |
| 80 | 1-3 Clutch Housing Assembly |
| 81 | Hybrid Direct, 2-3-4 Clutch Housing Thrust Bearing Assembly |
| 82 | Main Shaft Assembly |
| 83 | A/Trans Vent Pipe |
| 84 | A/Trans Case Assembly |
| 85 | 1-3 Clutch Housing Fluid Seal Ring |
| 86 | Center Support Assembly |
| 87 | Center Support Bolt |
| 88 | Drive Motor (w/Generator) Assembly - 2nd Position |
| 89 | Sun Gear Shaft Assembly - 3rd Position - Some Models |
| 90 | Sun Gear - 3rd Position |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.