SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C1500, 5.3 ZREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1966 (HYBRID/EV COOLING SYSTEM)REPAIR INSTRUCTIONSGENERATOR CONTROL MODULE COOLANT PUMP REPLACEMENT (LEFT)
2006 Chevrolet Suburban C1500, 5.3 Z

Generator Control Module Coolant Pump Replacement (Left)

2006 Chevrolet Suburban C1500, 5.3 ZSECTION Generator Control Module Coolant Pump Replacement (Left)
WARNING: This page is about a different car, the 2011 GMC Yukon, 2011 Chevrolet Tahoe, and 2011 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Generator Control Module Coolant Pump (Left)
GM1966995Courtesy of GENERAL MOTORS CORP.
Generator Control Module Coolant Pump Replacement (Left)

Callout Component Name

Preliminary Procedures

  1. Drain the cooling system. Refer to Generator Control Module Cooling System Draining and Filling .
  2. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  3. Remove the engine shield. Refer to Engine Shield Replacement .
  4. Remove the generator control module coolant pump hose (pump to pump) Refer to Generator Control Module Coolant Pump Hose Replacement (Pump to Radiator) , Generator Control Module Coolant Pump Hose Replacement (Pump to Pump) .
  5. Remove the generator control module coolant pump hose (pump to radiator) Refer to Generator Control Module Coolant Pump Hose Replacement (Pump to Radiator) , Generator Control Module Coolant Pump Hose Replacement (Pump to Pump) .
1 Generator Control Module Coolant Pump Bolt (Qty: 2)
CAUTION:

Refer to Fastener Caution .


Tighten 
9 N.m (80 lb in)
2 Generator Control Module Coolant Pump
TIP:  Disconnect electrical connector.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.