SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C1500, 5.3 ZREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1913 (POWER DOOR LOCK SYSTEM AND RELEASE SYSTEMS)REPAIR INSTRUCTIONSENDGATE HANDLE REPLACEMENT
2006 Chevrolet Suburban C1500, 5.3 Z

Endgate Handle Replacement

2006 Chevrolet Suburban C1500, 5.3 ZSECTION Endgate Handle Replacement
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Endgate Handle Assembly
GM1709358Courtesy of GENERAL MOTORS CORP.
Endgate Handle Replacement

Callout Component Name

Preliminary Procedure

  1. Remove the endgate trim panel. Refer to Endgate Trim Panel Replacement .
  2. Remove the endgate spoiler. Refer to Rear Spoiler Replacement (Avalanche/Escalade) .
1 Endgate Handle Bolt (Qty: 3)
CAUTION:

Refer to Fastener Caution .


Tighten 
25 N.m (18 lb ft)
2 Endgate Handle Assembly
  • Disconnect the actuator rods.
  • Disconnect the electrical connectors.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.