Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C1500, 5.3 ZREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1901 (CELLULAR SYSTEM, ENTERTAINMENT SYSTEM, AND NAVIGATION SYSTEM)REPAIR INSTRUCTIONSREAR SEAT AUDIO CONTROL REPLACEMENT
2006 Chevrolet Suburban C1500, 5.3 Z
Rear Seat Audio Control Replacement
2006 Chevrolet Suburban C1500, 5.3 ZSECTION Rear Seat Audio Control Replacement
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Rear Seat Audio Control Replacement
| Callout | Component Name |
|---|---|
| 1 | Front Floor Console Compartment Bezel Assembly Refer to Front Floor Console Compartment Bezel Replacement (Except Cadillac) , Front Floor Console Compartment Bezel Replacement (Cadillac) . |
| 2 | Rear Radio Control Assembly Screw (Qty: 4)
CAUTION:
Refer to Fastener Caution . TIP: Tighten the fasteners equally to ensure the control assembly seats evenly. Tighten 1.5 N.m (13 lb in) |
| 3 | Rear Radio Control Assembly Procedure Disconnect the electrical connectors from the rear radio control assembly. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.