SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C1500, 5.3 ZREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1892 (LIGHTING SYSTEM)REPAIR INSTRUCTIONSSTOP LAMP SWITCH REPLACEMENT (WITHOUT ADJUSTABLE PEDALS)
2006 Chevrolet Suburban C1500, 5.3 Z

Stop Lamp Switch Replacement (Without Adjustable Pedals)

2006 Chevrolet Suburban C1500, 5.3 ZSECTION Stop Lamp Switch Replacement (Without Adjustable Pedals)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Stop Lamp Switch (Without Adjustable Pedals)
GM2250601Courtesy of GENERAL MOTORS CORP.
Stop Lamp Switch Replacement (Without Adjustable Pedals)

Callout Component Name

Preliminary Procedures

  1. Apply the park brake.
  2. Remove the driver knee bolster. Refer to Knee Bolster Replacement (Except Cadillac) , Knee Bolster Replacement (Cadillac) .
  3. Disconnect the stoplamp switch electrical connector.
1 Power Vacuum Brake Booster Pushrod Retainer Bolt
CAUTION:

Refer to Fastener Caution .


Tighten 
10 N.m (89 lb in)
2 Power Vacuum Brake Booster Pushrod Retainer
Procedure 
Rotate the pushrod retainer 360 degrees to verify the retainer is fully engaged in the groove on the brake pedal pin.
3 Stoplamp Switch
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.