Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C1500, 5.3 ZREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1767 (REAR SUSPENSION SYSTEM)REPAIR INSTRUCTIONSREAR SPRING FRONT STOP REPLACEMENT

2006 Chevrolet Suburban C1500, 5.3 Z

Rear Spring Front Stop Replacement

2006 Chevrolet Suburban C1500, 5.3 ZSECTION Rear Spring Front Stop Replacement

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rear Spring Front Stop

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle . Remove the rear tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
1	Rear Spring Stop Bolts (Qty: 3) NOTE: For the left rear front spring stop, the fuel tank must be removed to gain access to the spring stop mounting bolts. Refer to Fuel Tank Replacement (35 Reg/Ext/Crew Cab With 34 Gal Tank) or Fuel Tank Replacement (15 Ext/Crew Cab With 26 Gal Tank) or Fuel Tank Replacement (15/25 Reg/Ext/Crw Cab With 34 Gal Tnk) or Fuel Tank Replacement (15 Rec Cab With 26 Gal Tank) or Fuel Tank Replacement (25 Ext/Crew Cab With 26 Gal Tank)
2	Rear Spring Stop Nuts (Qty: 3) CAUTION: Refer to Component Fastener Tightening Caution . Tighten: Tighten the bolt to 50 N.m (37 lb ft).
3	Rear Front Spring Stop

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.