Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C1500, 5.3 ZREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1736 (POWER TAKE-OFF SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESDTC P260DCIRCUIT/SYSTEM VERIFICATION
2006 Chevrolet Suburban C1500, 5.3 Z
Circuit/System Verification
2006 Chevrolet Suburban C1500, 5.3 ZSECTION Circuit/System Verification
WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Verify that the interior backlighting system operates normal. Refer to Interior Lighting Systems Description and Operation .
- Engine ON, press 1 on the PTO switch to engage PTO. The PTO LED indicator will turn on blinking at a 0.25 second interval rate when the PTO relay is energized. The indicator turns on solid once the PTO load feedback signal confirms the load has been engaged or after 3 seconds if load feedback is not utilized by the PTO system.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.