SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C1500, 5.3 ZREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1691 (FIXED AND MOVEABLE WINDOWS SYSTEM)REPAIR INSTRUCTIONSFRONT SIDE DOOR WINDOW REGULATOR REPLACEMENT (POWER)
2006 Chevrolet Suburban C1500, 5.3 Z

Front Side Door Window Regulator Replacement (Power)

2006 Chevrolet Suburban C1500, 5.3 ZSECTION Front Side Door Window Regulator Replacement (Power)
WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Front Side Door Window Regulator (Power)
GM1673129Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedures

  1. Position the door window as needed for service.
  2. Remove the front door trim panel. Refer to Front Side Door Trim Panel Replacement (SLT, A95) or Front Side Door Trim Panel Replacement (Except YE9 or SLT) .
  3. Remove the front door water deflector. Refer to Front Side Door Water Deflector Replacement .
1 Front Side Door Window Bolt (Qty: 2)
CAUTION: Refer to Fastener Caution .

Procedure

  1. Tape the window to the door frame to prevent it from moving.
  2. Loosen the 2 bolts that attach the window to the window regulator.
  3. Disconnect the electrical connector.

Tighten:  9 N.m (80 lb in)
2 Front Side Door Window Regulator Bolt (Qty: 3)

Tighten:  9 N.m (80 lb in)
3 Front Side Door Window Regulator Nut (Qty: 2)

Tighten:  9 N.m (80 lb in)
4 Front Side Door Window Regulator
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.