Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C1500, 5.3 ZREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1269 (ENGINE COOLING SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESDTC P1258CIRCUIT/SYSTEM VERIFICATION
2006 Chevrolet Suburban C1500, 5.3 Z
Circuit/System Verification
2006 Chevrolet Suburban C1500, 5.3 ZSECTION Circuit/System Verification
WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
If DTCs P0480, P0481, P0691, P0692, P0693, or P0694 are set, diagnose those DTCs first.
- Observe the engine coolant level. The engine coolant level should be within operating range. Refer to Capacities - Approximate Fluid, and Engine Coolant in the Owner's Manual.
- Ensure that the vehicle has the correct engine coolant, with correct concentration, and is not old, contaminated or contains additives. Refer to Recommended Fluids and Lubricants in the Owner's Manual.
- Inspect the cooling system for the following:
- Cooling system leaks
- Kinked or pinched hoses, especially at the radiator
- Loose, missing, or damaged radiator air seals or deflectors
- The radiator and A/C condenser for any air flow obstructions or bent fins. Refer to Symptoms - Engine Cooling .
- Command the cooling fans in both low and high speed.
- If the cooling fans do not operate in both speeds, refer to Cooling Fan Inoperative .
IMPORTANT:
A small delay occurs before the ECM changes the cooling fan speed.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.