Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C1500, 5.3 ZREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1264 (SUNROOF SYSTEM)REPAIR INSTRUCTIONSSUNROOF TRACK TIMING/SYNCHRONIZATIONINSTALLATION PROCEDURE

2006 Chevrolet Suburban C1500, 5.3 Z

Installation Procedure

2006 Chevrolet Suburban C1500, 5.3 ZSECTION Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Refer to Fastener Notice .

Install the sunroof window. Refer to Sunroof Window Replacement - Front .
Tighten: Tighten the screws to 4 N.m (35 lb in).
Install the motor/actuator. Refer to Sunroof Motor/Actuator Replacement .
Tighten: Tighten the motor attachment screws to 3.5 N.m (31 lb in).
Connect the electrical connector to the motor/actuator.

Fig 1: Identifying Pin And Hole Of Mechanism Arm

Courtesy of GENERAL MOTORS CORP.

Remove the pin (1) from the holes that held the position while installing the drive motor.
Install the headliner. Refer to Headlining Trim Panel Replacement .
Perform the Initialization/Teach Procedure. Refer to Sunroof Motor/Actuator Initialization/Teach Process .
Verify the operation of the sunroof.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.