SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C1500, 5.3 ZREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1257 (COMPONENT LOCATIONS & COMPONENT CONNECTOR END VIEWS)COMPONENT CONNECTOR END VIEWSFRONT PASSENGER DOOR MODULE (FPDM) X7
2006 Chevrolet Suburban C1500, 5.3 Z

Front Passenger Door Module (FPDM) X7

2006 Chevrolet Suburban C1500, 5.3 ZSECTION Front Passenger Door Module (FPDM) X7
WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Front Passenger Door Module (FPDM) X7 Connector End View
GM1664543Courtesy of GENERAL MOTORS CORP.
Front Passenger Door Module (FPDM) X7

Pin Wire Circuit Function
1 0.35 YE 5004 Passenger Folding Mirror Motor Extend Control (DL7/D26)
2 0.35 L-BU 5023 Passenger Folding Mirror Motor Retract Control (DL7/D26)
3 - - Not Used
4 0.35 BN 787 Passenger Mirror Vertical Position Sensor Signal (A45)
5 0.35 L-BU/BK 785 Passenger Mirror Horizontal Position Sensor Signal (A45)
6 - - Not Used
7 0.35 YE 674 5-Volt Reference (A45)
8-9 - - Not Used
10 0.35 L-GN 675 Low Reference (A45)
Connector Part Information 
  • OEM: 15127040
  • Service: See Catalog
  • Description: 10-Way F (BK)
Terminal Part Information 
  • Pins: 1, 2, 4, 5, 7, 10
  • Terminal/Tray: 7116-4618-02
  • Core/Insulation Crimp: P/P
  • Release Tool/Test Probe: See Terminal Repair Kit
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.