SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C1500, 5.3 ZREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1248 (FRONT SUSPENSION SYSTEM)REPAIR INSTRUCTIONSSHOCK ABSORBER AND SPRING ASSEMBLY REPLACEMENTINSTALLATION PROCEDURE
2006 Chevrolet Suburban C1500, 5.3 Z

Installation Procedure

2006 Chevrolet Suburban C1500, 5.3 ZSECTION Installation Procedure
WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Shock Module
    GM1209263Courtesy of GENERAL MOTORS CORP.
  1. Install the front shock absorber assembly in the vehicle.
    2. NOTE: Refer to Fastener Notice .
  2. Install the front shock assembly upper mounting bolts.

    Tighten:  Tighten the bolts to 112 N.m (83 lb ft).

  3. Raise the vehicle.
    4. Fig 2: View Of Upper Control Arm Ball Stud-To-Steering Knuckle Retaining Nut
    GM1209256Courtesy of GENERAL MOTORS CORP.
  4. Install the upper control arm to the steering knuckle.
  5. Install the upper control arm to steering knuckle retaining nut.

    Tighten:  Tighten the nut to 80 N.m (59 lb ft).

    6. Fig 3: Removing & Installing Lower Shock Bolts
    GM742959Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.