Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC Descriptors
- DTC C0035 02
-
Left Front Wheel Speed Sensor Circuit Short to Ground
- DTC C0035 05
-
Left Front Wheel Speed Sensor Circuit Short to Battery or Open
- DTC C0035 0F
-
Left Front Wheel Speed Sensor Circuit Erratic Signal
- DTC C0035 18
-
Left Front Wheel Speed Sensor Circuit Signal Amplitude Less Than Minimum
- DTC C0040 02
-
Right Front Wheel Speed Sensor Circuit Short to Ground
- DTC C0040 05
-
Right Front Wheel Speed Sensor Circuit Short to Battery or Open
- DTC C0040 0F
-
Right Front Wheel Speed Sensor Circuit Erratic Signal
- DTC C0040 18
-
Right Front Wheel Speed Sensor Circuit Signal Amplitude Less Than Minimum
- DTC C0045 02
-
Left Rear Wheel Speed Sensor Circuit Short to Ground
- DTC C0045 05
-
Left Rear Wheel Speed Sensor Circuit Short to Battery or Open
- DTC C0045 0F
-
Left Rear Wheel Speed Sensor Circuit Erratic Signal
- DTC C0045 18
-
Left Rear Wheel Speed Sensor Circuit Signal Amplitude Less Than Minimum
- DTC C0050 02
-
Right Rear Wheel Speed Sensor Circuit Short to Ground
- DTC C0050 05
-
Right Rear Wheel Speed Sensor Circuit Short to Battery or Open
- DTC C0050 0F
-
Right Rear Wheel Speed Sensor Circuit Erratic Signal
- DTC C0050 18
-
Right Rear Wheel Speed Sensor Circuit Signal Amplitude Less Than Minimum
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.